国产精品欧美激情另类小说-中文亚洲免费在线观看-日韩国产欧美在线精品-久久这里只有精品视频98-国产激情在线观看免费完整网站-免费视频一区二区在线观看-亚洲二区欧美日韩-国产精品久久av高潮呻吟-亚洲av永久综合网站美女-日韩国产美女在线观看

　　實驗室通風系統是實驗室中非常重要的一個系統，實驗室通風管道的正確安裝對于確保通風系統運行有效和節能，是一個很重要的環節。今天我們就來看一下實驗室通風管道安裝時需要避免的一些問題。

　　The laboratory ventilation system is a very important system in the laboratory, and the correct installation of laboratory ventilation ducts is a crucial step in ensuring the effective and energy-saving operation of the ventilation system. Today we will take a look at some issues that need to be avoided when installing laboratory ventilation ducts.

　　01  風管安裝前未清除內部雜物

　　01 Failure to remove internal debris before installing the air duct

　　風管安裝前應清除內、外雜物，并做好清潔和成品，施工后及時封堵管口，如不清除雜物，將會造成系統阻力增大，嚴重時堵塞過濾網和管道。

　　Before installing the air duct, internal and external debris should be removed, and cleaning and finishing should be done well. After construction, the pipe mouth should be promptly sealed. If the debris is not removed, it will cause an increase in system resistance, and in severe cases, it may block the filter screen and pipeline.

　　02  風管系統安裝后不按規定作漏光、漏風檢查和試驗

　　02 Failure to conduct light and air leakage inspections and tests as required after installation of the air duct system

　　漏光或漏風量測定是對通風空調施工質量的一項檢驗措施，必須嚴格按要求規范進行檢驗，若風管系統安裝后不按規定作漏光、漏風檢查和試驗，可能會造成系統大量漏風，使整個系統和項目工程達不到使用要求，增加不必要的返工和浪費，同時也浪費了能源。

　　Leakage or air leakage measurement is an inspection measure for the construction quality of ventilation and air conditioning, which must be strictly inspected according to the required specifications. If the air duct system is not inspected and tested for leakage and air leakage according to regulations after installation, it may cause a large amount of air leakage in the system, making the entire system and project engineering unable to meet the requirements for use, increasing unnecessary rework and waste, and also wasting energy.

　　03   風閥安裝位置不便于操作和檢修

　　The installation position of the 03 air valve is not convenient for operation and maintenance

　　各類風閥應安裝在便于操作及檢修的部位，吊頂或井道內設置檢修口。

　　All types of air valves should be installed in locations that are easy to operate and maintain, with maintenance ports set up in suspended ceilings or shafts.

　　04   風管支、吊架間距過大

　　04 The spacing between air duct supports and hangers is too large

　　風管支吊架的間距過大，會造成風管變形，影響感官效果；如果膨脹螺栓使用不當，風管的重量超過吊點的承載力甚至會造成風管墜落，出現施工安全隱患。

　　The spacing between air duct supports and hangers is too large, which can cause deformation of the air duct and affect the sensory effect; If the expansion bolt is used improperly, the weight of the air duct may exceed the bearing capacity of the lifting point and even cause the air duct to fall, posing a construction safety hazard.

　　05   風管系統采用組合式法蘭連接時接口漏風

　　When the 05 duct system adopts a combination flange connection, there is air leakage at the interface

　　接口漏風不符合質量標準，將會造成整個系統風量損失過大，無法滿足風量要求，并造成能源嚴重浪費。

　　Interface air leakage that does not meet quality standards will cause excessive loss of air volume in the entire system, unable to meet air volume requirements, and result in serious energy waste.

　　06   磚結構風道與金屬風管連接處未設預埋件或密封縫隙過大或連接處不嚴密

　　The connection between the 06 brick structure air duct and the metal air duct is not equipped with embedded parts or the sealing gap is too large or the connection is not tight

　　07   柔性短管、矩形短管安裝時產生扭曲

　　Twisting occurs during the installation of flexible short pipes and rectangular short pipes in 07

　　短管扭曲易產生質量問題，也影響美觀，在安裝時需要特別留意。

　　Twisting short pipes can easily cause quality problems and also affect aesthetics, so special attention should be paid during installation.

　　08   防排煙系統的柔性短管采用易燃材料

　　The flexible short pipe of the 08 smoke control system is made of flammable materials

　　防排煙系統柔性短管的制作材料必須為不燃材料，且應選用防腐、防潮、不透氣、不易霉變的柔性材料。用于空調系統的應采取防止結露的措施；用于空調凈化系統的還應是內壁光滑、不易產生塵埃的材料。

　　The production material of flexible short pipes for smoke control systems must be non combustible materials, and flexible materials that are corrosion-resistant, moisture-proof, airtight, and not easily moldy should be selected. Measures to prevent condensation should be taken for air conditioning systems; Materials with smooth inner walls and low dust generation should also be used for air conditioning purification systems.

　　09   風管系統不設置防擺支架

　　09 Duct system does not have anti sway brackets installed

　　在實驗室通風管道安裝時，當水平懸吊的主、干風管長度超過20m時，應設置防止擺動的固定點，每個系統不應少于1個，如果不設置，則系統運行時會產生風管移動、震動。

　　When installing ventilation ducts in the laboratory, if the length of the horizontally suspended main and main air ducts exceeds 20m, fixed points to prevent swinging should be set up, and each system should not be less than 1. If not set up, the air ducts will move and vibrate during system operation.

　　本文由  山東通風管道 友情奉獻.更多有關的知識請點擊  http://www.jnhxtcg.com/   真誠的態度.為您提供為全面的服務.更多有關的知識我們將會陸續向大家奉獻.敬請期待.

　　This article is a friendly contribution from Shandong Ventilation Duct For more related knowledge, please click http://www.jnhxtcg.com/ Sincere attitude To provide you with comprehensive services We will gradually contribute more relevant knowledge to everyone Coming soon.